Adding second parameter shows options from previous parameter

[5iver]

I created one parameter and added options for it. I added a second parameter and the options from the first were displayed.

After saving the second parameter with one of the options modified and opening the first parameter, the options were blank. Opening the second parameter, the options were also blank. Where did the options go 😮?

After reentering the options and saving, they seem to not be disappearing any more. Until I entered a third parameter and the options for parameter 1 showed up. I entered another option and saved, but when reopening parameter 3, the options were gone.

[cdjackson]

I've updated this to reset the form when the ADD button is pressed - this should clear everything out.

[5iver]

I just observed something similar. When adding a new parameter to an existing device (ZEN16 firmware < 1.0), two options show up. After saving the device, the options are gone.

[bwosborne2]

T had a similar experience. I viewed a parameter with existing options but made no changes. Later, when adding a parameter, those "ghost options" appeared. I call them ghosts because even if you set them, they do not save with the parameter.

[bwosborne2]

Today I tested this with 3 different browsers and had the same results, In addition, when adding a new parameter without the ghost options but adding options. those options are not saved. You need to open the parameter & edit to add the options again.

Verified in Chrome. Firefox,, & Edge browsers.